RTCOutboundRtpStreamStats: pliCount property
The pliCount
property of the
RTCOutboundRtpStreamStats
dictionary states the number of times the
remote peer's RTCRtpReceiver
sent a Picture Loss
Indication (PLI) packet to the RTCRtpSender
for which this object provides statistics.
A PLI packet indicates that some amount of encoded video data has been lost for one or more frames.
Value
An integer value indicating the number of times a PLI packet was sent to this sender by
the remote peer's RTCRtpReceiver
. These are sent by the receiver's
decoder to notify the sender's encoder that an undefined amount of coded video data,
which may span frame boundaries, has been lost.
Note: This property is only used for video streams.
Usage notes
Upon receiving a PLI packet, the sender may have responded by sending a full frame to
the remote peer to allow it to re-synchronize with the media. However, the primary
purpose of a PLI packet is to allow the RTCRtpSender
for which this
RTCOutboundRtpStreamStats
object provides statistics to consider techniques
to mitigate network performance issues. This is often achieved by methods such as
increasing the compression or lowering resolution, although the mechanisms available to
reduce the bit rate of the stream vary from codec to codec.
Specifications
No specification found
No specification data found for api.RTCOutboundRtpStreamStats.pliCount
.
Check for problems with this page or contribute a missing spec_url
to mdn/browser-compat-data. Also make sure the specification is included in w3c/browser-specs.
Browser compatibility
BCD tables only load in the browser
See also
- RFC 4585, section 6.3.1: Definition of "PLI messages" in the document Extended RTP Profile for Real-time Transport Control Protocol (RTCP)-Based Feedback (RTP/AVPF).